Michigan Reefers banner
1 - 3 of 3 Posts

·
Registered
Joined
·
69 Posts
Discussion Starter · #1 ·
Can anyone share there failsafe programming that is using a ATO with kalk mix?

I have a float switch but would like to program a second fail safe that would only let the ATO run a few seconds ever hour or so to limit ph spikes etc. Just having a hard time figure out the proper way.

Thanks
 

·
Administrator
Joined
·
2,496 Posts
ato outlet

Fallback OFF
Set OFF
If Switch2 CLOSED Then ON Float switch is down give water
If Switch2 OPEN Then OFF Float switch is up dont give water
If Outlet VO_TopOff = OFF Then OFF Check status of timmer
If pH > 08.30 Then OFF - turn off if ph is greather than 8.3


virtual outlet VO_TopOff

Fallback OFF
Set OFF
OSC 000:00/001:00/059:00 Then ON - dose the 1st minute of every hour turn on
 
1 - 3 of 3 Posts
Top