Michigan Reefers banner
1 - 6 of 6 Posts

·
Registered
Joined
·
304 Posts
Discussion Starter · #1 ·
im looking to do the 4x24watt pc upgrade through nanocustoms. my question is that will i have to use my orig. ballast in my transformer box or will they supply new ones? the reason being is i dont think my current ballast is outputting to the 2nd bulb because when i switch the plug for each cord the other light comes on and not both at the same time. so i can resolve this if they send all replacement ballasts in this system or do i have to use the one that is hooked up now as well as an additional.
 

·
Registered
Joined
·
1,588 Posts


1 - Nanocustoms 4 x 24w Heat Shield
2 - Fulham Workhorse 3C - 48w
2 - BJB GX11 Lampholder prewired to Remote Ballast Lead
2 - BJB Bulb Clip
1 - AC Powercord
1 - Power Switch
1 - Bulb Clip
1 - Hole Plug
2 - Evercool 60x60x10mm Fan
Since it says it's only a 48w ballast this is only to run the two new bulbs the retrofit adds - so you'll still need to use your original one as well.
 

·
Registered
Joined
·
547 Posts
They come with 2 ballasts I am pretty sure, and the for the plugs... One has room for 5 pins and one has room for 4 pins, and they both have 4 pins in them, just different so you dont get them mixed up. I will have to ask my brother about the ballasts as he has that setup on his DX
 
1 - 6 of 6 Posts
Top